Paul Berube asked me to forward this message to you (he is working
from home tonight and cannot email directly to the class.
You can see his hand drawn block diagram at
http://www.cs.ualberta.ca/~amaral/courses/329/labs/lab3block.jpg
> ok, it is rather crude (drawing by hand is not my specialty), but here
> you are. this shows all the connections between modules and the widths
> of the busses. please remeber that you can (hint: this would make it
> easier) decompose the encrytion and decryption units into smaller
> pieces. You can put them on a sub-schematic, or just put it all on the
> top level schematic - your choice.
>
> pin numbers are not indicated on the diagram. use those from the
> original diagram, or look them up in the board manuals (it's at the
> back).
>
> hope this helps.
--Cheers,
Nelson
/ \ / / Jose Nelson Amaral - amaral@cs.ualberta.ca ) / ( Associate Professor / / \ Dept. of Computing Science - University of Alberta ( / ) Edmonton, Alberta, Canada, T6G 2E8 \ O / Phone: (780)492-5411 Fax: (780)492-1071 \ / http://www.cs.ualberta.ca/~amaral `----'
This archive was generated by hypermail 2.1.3 : Wed Nov 21 2001 - 15:50:12 MST
